Adding a 26-bit card (Such as an HID iClass Credential)

Adding a 26-bit card (Such as an HID iClass Credential)

  1. Connect the USB reader into an available USB port at the workstation (It does not have to be the host workstation, it can be on a remote client).
  2. The USB reader will be automatically detected.
  3. Log into the Doors.NET software.
  4. Go to Home >> Cardholders.
  5. Click the Add icon.

    Add

  6. Enter a first name and last name (optionally a middle name) then save the new record.

    New HID Record

  7. If you look at the credential section of the cardholder record you will see a new button labelled USB Enroll.

    USB Enroll Button

  8. Ensure Calculate Internal Number is checked (1).
  9. Ensure 26-bit Wiegand is selected (2).
  10. Ensure Status is set to Active (3).

    NEW Card Enrollment Settings

  11. Hold the new card near to the USB Enrollment reader.
  12. The reader will beep and the LED should go green.
  13. Continue to hold the card near the reader and the LED will remain green.
  14. While the LED is green, press the USB Enroll button.
  15. The facility code, imprint and calculated internal number will all be displayed.

    USB Enroll New Record

  16. Click the Add Card button and the card number will be added to the cardholder record.

    USB New Card Add

  17. Click the save icon in the upper left (or Save All).

    Save All Icon

  18. Finally go to the Access Rights tab and assign the cardholder an access group. When you have saved the access group assignment, the new card will automatically be sent out to the controller network.
  19. Present a card to any reader that is included in the cardholder's access group and you should get access granted.

    USB New Access

    • Related Articles

    • Adding Non-26-bit Cards

      If you do not know the programmed card format ​ One of the main benefits of the USB enrollment reader is to enroll 'unknown formats' - for example Mifare CSN (Card Serial Numbers) - These are usually 32 bits. Note: PXL controllers will only read a ...

    • Enrolling a Mifare Card in Doors.NET

      From within Doors.NET go to Home >> Cardholders. Click the Add button. Enter a first name and last name. Then save . If the USB reader is still plugged into the host PC you should be seeing a USB Enroll button. Verify that Calculate Internal ...

    • Installing the pcProxConfig Software

      Note: This product is only supported for use as of Doors.NET version 3.5.1.22   The pcProx configuration software is a third-party utility that allows you to configure the desired credential data output for the reader. The software is quick and easy ...

    • Using the pcProxConfig Software

      From the Windows start menu, go to All Apps >> RF Ideas >> pcProxConfig.exe The user interface will appear as below. Plug the pcProx Plus USB enrollment reader into an available USB port. The reader will beep once and its LED will be red. Verify ...