Connecting a Request to Exit (RTE) Input

Connecting a Request to Exit (RTE) Input

Press button to close circuit and Activate RTE A-Door Input


Request to Exit Input Connections​

    • Related Articles

    • Connecting a General Purpose Input

      The general-purpose input is used in conjunction with the programmable input/output feature of the Doors access control software. There are three possible uses for the general-purpose input. • the primary controller (#1) may be figured for either ...

    • Connecting a Door Status Input

      Each PXL-500 is shipped with an installation kit including all necessary terminal blocks and transorbs. One of these terminal blocks has a jumper across pins 1 and 2. This terminal block is designated for use on TB-4. If a door switch is not used on ...

    • Input/Output (I/O) Control - Using PXL-500 Controllers

      1.0 Introduction Using Doors.NET v3.5.1.21 and higher, you can apply basic I/O linkage actions to a PXL-500 controller which has an SB-593 satellite board connected to it. The SB-593 provides a PXL-500 with an additional 8 general purpose inputs and ...

    • PXL-500 Hardware Installation Guide

      1.0 Introduction This document contains installation guidelines and wiring diagrams for the installation of the PXL-500 Controller. Notes: A Serial connection is only supported when using the Doors.NET software. If using the PXL controller in ...

    • Connecting an Alarm Output Relay

      Connecting an Alarm Output Relay Alarm Output Relay Connections