Connecting an Alarm Output Relay

Connecting an Alarm Output Relay

Connecting an Alarm Output Relay


Alarm Output Relay Connections

    • Related Articles

    • Input/Output (I/O) Control - Using PXL-500 Controllers

      1.0 Introduction Using Doors.NET v3.5.1.21 and higher, you can apply basic I/O linkage actions to a PXL-500 controller which has an SB-593 satellite board connected to it. The SB-593 provides a PXL-500 with an additional 8 general purpose inputs and ...

    • PXL-500 Quick Start Guide

      1.0 Introduction This quick start guide provides, basic installation information, drawings, first time power-on instructions, and short descriptions of key terms and concepts for installing controllers. These instructions apply to the PXL-500 ...

    • PXL-500P MS Reader Connecting

      Connecting a Keri Systems Proximity Reader to a PXL-500P/PXL-510P • The "A" reader is wired to TB5. • The "B" reader is wired to TB6.

    • Connecting a General Purpose Input

      The general-purpose input is used in conjunction with the programmable input/output feature of the Doors access control software. There are three possible uses for the general-purpose input. • the primary controller (#1) may be figured for either ...

    • Connecting a Door Status Input

      Each PXL-500 is shipped with an installation kit including all necessary terminal blocks and transorbs. One of these terminal blocks has a jumper across pins 1 and 2. This terminal block is designated for use on TB-4. If a door switch is not used on ...