Doors.NET - Add a Standard NXT Controller Using Auto-Config

• Related Articles

• Doors.NET - Add an NXT-MSC Controller Using DHCP

  This video explains how to add the NXT-MSC controller to the Doors.NET software using DHCP address assignment. ​

• Doors.NET - Add an NXT-MSC Controller using a Static IP Address

  This video explains how to add the NXT-MSC controller to the Doors.NET software via no-DHCP address assignment. ​

• Doors.NET - NXT Proxy Service

  1.0 Introduction The Doors.NET NXT Proxy service is the service that looks for and detects the NXT controllers on the network. It supports auto-config 'discovery and assignment' requests and auto-config will not function without the NXT Proxy ...

• Setup an NXT Controller

  Introduction This document covers the basic configuration of NXT controllers in Doors.NET software. It assumes Doors.NET has already been successfully installed on your host PC, the software license has been activated, and the gateway has been ...

• Doors.NET - Using Multiple Hardware Platforms

  Doors.NET - Using Multiple Hardware Platforms (PDF) P/N: 01268-001 Rev. C (attached)