End of PXL and Entraguard Support in Doors.NET
Support for PXL and Entraguard has now Ended in Doors.NET
The PXL and Entraguard controller types are not supported with this version of Doors.NET (v6.0.0) and future versions. These controller types are not end-of-life,
ongoing support and development for these products will be in Borealis.
Version 5.4.0.8 was the last version of Doors.NET that supported PXL and Entraguard controllers. This version of Doors.NET can be downloaded from the kerisys.com website: https://downloads.kerisys.com/downloads/
Note: To download any version of the Doors.NET software you must have registered an account and then verified the new account via the welcome email.
The Doors.NET v6.0.0 installer will check the database for a PXL gateway. If one exists locally then the software installation will not proceed. If there is a PXL gateway installed and running on a remote PC, the installer will prompt you to stop the gateway service and the PXL gateway will be removed during the software installation/update.
Related Articles
Information Regarding Future Change in Modem Support in Doors.NET
End-of-Life for PXL and Entraguard Modem Communication Keri has decided to delay removing support for modem communication for PXL and Entraguard units to the next software release. Doors.NET v4.8.0 will be the last software revision that will support ...PXL-500 Hardware Installation Guide
1.0 Introduction This document contains installation guidelines and wiring diagrams for the installation of the PXL-500 Controller. Notes: A Serial connection is only supported when using the Doors.NET software. If using the PXL controller in ...PXL-500 Setup in Doors.NET with a LAN-520
1.0 Introduction The following are basic setup instructions for the LAN-520 module. Some settings may not apply to every application. Note: The LAN-520 AESP is an updated version of Keri’s LAN-520X device. If you are using the new NC-485X Network ...PXL-500 Setup in Doors.NET With a USB-Serial Adapter
1.0 Introduction This guide explains how to setup a connection to a PXL-500 Primary controller using a USB-serial adapter. The adapter used in this example is the Keyspan 19-HS by TRIPP-LITE which is one that Keri highly recommends. It is robust, ...PXL-500 Controller Setup - Doors.NET or Borealis
1.0 Introduction This section covers the initial setup and basic configuration of PXL controllers in the Doors.NET and Borealis software. If Using Doors.NET It assumes Doors.NET has already been successfully installed on your host PC, the software ...