USB Reader - Enrolling a 26-bit Credential

USB Reader - Enrolling a 26-bit Credential

  1. Connect the USB reader into an available USB port at the workstation (It does not have to be the host workstation, it can be on a remote client)
  2. The USB reader will be automatically installed.
  3. Log into the Doors.NET software.
  4. Go to Home >> Cardholders.
  5. Click the Add icon.

    Add

  6. Enter a first name and last name (optionally a middle name) then save the new record.

    New HID Record

  7. If you look at the credential section of the cardholder record you will see a new button labelled USB Enroll.

    USB Enroll Button

  8. Ensure Calculate Internal Number is checked (1).
  9. Ensure 26-bit Wiegand is selected (2).
  10. Ensure Status is set to Active (3).

    NEW Card Enrollment Settings

  11. Hold the new card near to the USB Enrollment reader.
  12. The reader will beep and the LED should go green.
  13. Continue to hold the card near the reader and the LED will remain green.
  14. While the LED is green, press the USB Enroll button.
  15. The facility code, imprint and calculated internal number will all be displayed.

    USB Enroll New Record

  16. Click the Add Card button and the card number will be added to the cardholder record.

    USB New Card Add

  17. Click the save icon in the upper left (or Save All).

    Save All Icon

  18. Finally go to the Access Rights tab and assign the cardholder an access group. When you have saved the access group assignment, the new card will automatically be sent out to the controller network.
  19. Present a card to any reader that is included in the cardholder's access group and you should get access granted.

    USB New Access