Excluding a Reader From Your Subscription

Excluding a Reader From Your Subscription

1.0 Introduction

A Borealis system incurs a charge any readers that will be used on the system. By default all of the readers on a controller are set to be included in the subscription (even if there is no reader physically connected to the reader port).

They may, however, be a situation where you have a 4-door controller but only 3 of those readers will be used. In this situation you will need to exclude the reader from the subscription (to prevent the reader subscription being charged). The following steps explain how to exclude a reader from your Borealis subscription.


2.0 Excluding a Reader from the Borealis Subscription

This section assumes you have added a controller to Borealis but the subscription for the controller has not yet been paid.
  1. Log into Borealis with your username and password.
  2. Select Hardware >> Readers from the menu on the left.
  3. A list of all readers on the system will appear.



  4. Place a checkmark in the checkbox next to the reader name (to select the reader). 
  5. From the Actions drop-down list select Remove from Subscription.



  6. The reader will no longer be added to the Borealis subscription.

    • Related Articles

    • Reader Settings

      1.0 Introduction The following section explains how to modify and use all the reader settings that are supported by NXT and NXT-MSC controllers when using Borealis. 2.0 Reader Settings (NXT Controller) To access the settings of a reader connected to ...

    • OSDP Reader Setup

      1.0 Introduction OSDP readers are supported in Borealis when using NXT-MSC or True Mercury controllers. Note: Currently Borealis will support one OSDP reader per controller bus. OSDP (Open Supervised Device Protocol) is an access control ...

    • Add an NXT Exit Reader

      1.0 Introduction When using NXT-MSC controllers you can use NXT Exit readers. An exit reader is wired into the same bus as a standard NXT entry reader (as illustrated), to control entrance and exit through a single door. Although just one door will ...

    • NXT 6RK Reader/Keypad Setup

      1.0 Introduction The following document explains how to setup an NXT 6RK keypad in Borealis. The document then goes on to explain some basic reader configuration. The NXT-6RK connects to a Standard NXT, Keri KB or NXT-MSC controller via a Reader ...

    • BioSync Fingerprint Reader User Enrollment

      1.0 Introduction Once BioSync users have been enrolled using the BioManager software they are automatically uploaded to the BioSync fingerprint readers along with the credential number that's associated with the user. Both the user's credential and ...