Intelliprox Blue - Factory Reset
Intelliprox Blue - Factory Reset Procedure
Before initially connecting to the controller you will need to perform a factory reset on it.
- Down-power the controller.
- Ensure the jumper is across both pins of the P2 jumper.
- Hold down the orange reset button (labelled K2) as you apply the power.
- Continue to hold down the K2 button for 20 seconds.
- You will notice the green DS1 LED go off then on (twice).
- Release your finger from the K2 button. The
DS4 and DS5 LEDs next to the reader port will start blinking very
quickly. The controller is now reset and ready to setup.
Note: If the app is open
when you perform the factory reset, Keri recommends closing then
re-opening the app to avoid any connection difficulties.
Related Articles
Intelliprox Blue - Troubleshooting
The following Intelliprox Blue troubleshooting guide helps you to track down the cause of many installation or user issues: 1.0 The Controller Does not Power-Up The controller does not power-up (there are no LEDs displayed on the controller or the ...Intelliprox Blue - Quick Start Guide
Introduction This quick start guide walks you through the steps to take to get your Intelliprox Blue system up and running for the first time. Factory Reset Before connecting to the controller for the first time, you will need to perform a factory ...Intelliprox Blue - Full Reference Manual
1.0 Introduction The Intelliprox Blue is a one-door/two-reader Bluetooth® controller designed to grant access to a single point of entry for up to 250 cardholders. Economical Intelliprox Blue grants access to a single point of entry, and is designed ...Intelliprox Blue - Hardware Installation Guide
Hardware Installation Guide 1.0 Introduction This document provides wiring diagrams, installation recommendations and further hardware information for the Intelliprox Blue controller. 2.0 Wiring Diagrams 2.1 Controller Diagram 2.2 Fail-Safe Lock ...Intelliprox Blue Data Sheet
Intelliprox Blue Controller Data Sheet