NXT-MSC NXT and NXT Exit Reader Wiring

• Related Articles

• NXT Exit Reader Setup

  NXT Exit Reader Setup Keri NXT controllers with Mercury Firmware now provide an Entrance/Exit reader door control feature/configuration. This Entrance/Exit feature allows two readers to be wired into one bus on the NXT controller to control entrance ...

• NXT Reader Setup

  1.0 Introduction NXT Readers are used use exclusively with Keri’s revolutionary access control system based on the NXT and the MSC Series of IP-based Controllers. Communication to the readers is via the RS-485 buses allowing the data to be encrypted ...

• NXT Primary and Secondary Reader Setup

  1.0 Introduction When using a Standard NXT controller it is not possible to use an NXT Exit reader (with the part number NXT-1RE/NXT-3RE or NXT-5E) - which would be wired into the same bus as a standard NXT reader. These readers are only supported on ...

• NXT-1R/-3R/-5R Reader - Installation Guide

  1.0 Wiring and Layout Diagrams 1.1 NXT-1R/-3R/-5R Readers This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable ...

• NXT 6RK Reader and Keypad Installation Guide

  The Keri NXT-6RK is a keypad reader typically used for card + PIN dual verification applications. It transmits keypad data in either 8-bit burst (default) or 26-bit Wiegand formats and can be used as a keypad-only device. Since the NXT-6RK ...