NXT Controller 3-State and 4-State Supervision Wiring

NXT Controller 3-State and 4-State Supervision Wiring

Attached.
    • Related Articles

    • NXT 2D/4D Controller Specifications

      Size (Enclosure): 13.125” H x 10.625” W x 3.06” D (33.34 cm x 26.99 cm x 7.77 cm) Size (PC Board): 5.6” H x 6.6” W x 2.55” D (14.28 cm x 16.83 cm x 2.55 cm) Weight (In Enclosure): 4.95 Lbs (2.25 Kgs) Input Voltage: + 12 VDC nom. (10 - 14 VDC) Current ...
    • NXT 2D/4D Controller Factory Reset

      Keri recommends resetting NXT controllers the first time these controllers are powered on. Also, under certain circumstances NXT controllers may need to be reset. Note: Factory resetting a standard NXT controller will restore the controller to a ...
    • Standard NXT Controller Setup

      NXT Controller Setup NXT 4 door controller Introduction This document covers the basic configuration of NXT controllers in Doors.NET software. It assumes Doors.NET has already been successfully installed on your host PC, the software license has been ...
    • NXT Controller Firmware Upgrade

      1.0 Introduction When you run the Doors.NET installer you will see an Application Requirements window. This window will inform you if standard NXT controllers need a firmware upgrade and the version they should be upgraded to.     There will also be ...
    • CSA Certification for NXT Controller

      CSA Certification for NXT Controllers