Related Articles
NXT GIOX Specifications
Specifications Dimensions Stand Alone Unit with Back Plate • 15.45 inches wide by 11.56 inches tall by 2.00 inches deep Unit in Standard Enclosure • 17.25 inches wide by 15.25 inches high by 6.75 inches deep (including enclosure cover) Power and ...
NXT GIOX - Hardware Installation Guide
1.0 Introduction The GIOX unit can be used either for elevator control or for large scale general I/O (you cannot perform both functions on the same GIOX unit). It is made up of a motherboard, input modules, and output modules, all mounted to a back ...
NXT GIOX - LED Definitions
With GIOX Firmware 01.00.21, the LEDs have the following functions: USER LED2 - reserved for future use USER LED1 - reserved for future use DIAG - lit if board is REV B or older. Current is PCB REV C, marked on back upper left. PWR FAULT - Current ...
NXT GIOX - Setup and Configuration in Doors.NET
1.0 Using Standard NXT Controllers The NXT GIOX module is added to standard NXT controllers using Auto-configuration. The GIOX module is connected to the controller via one of the available RS-485 ports (these are labeled on a 4-door controller as ...
NXT GIOX - Elevator Control Wiring