NXT GIOX - Input Board Wiring

NXT GIOX - Input Board Wiring



    • Related Articles

    • NXT GIOX Specifications

      Specifications Dimensions Stand Alone Unit with Back Plate • 15.45 inches wide by 11.56 inches tall by 2.00 inches deep Unit in Standard Enclosure • 17.25 inches wide by 15.25 inches high by 6.75 inches deep (including enclosure cover)   Power and ...

    • NXT GIOX - Hardware Installation Guide

      1.0 Introduction The GIOX unit can be used either for elevator control or for large scale general I/O (you cannot perform both functions on the same GIOX unit). It is made up of a motherboard, input modules, and output modules, all mounted to a back ...

    • NXT GIOX - LED Definitions

      With GIOX Firmware 01.00.21, the LEDs have the following functions: ​ USER LED2 - reserved for future use USER LED1 - reserved for future use DIAG - lit if board is REV B or older.  Current is PCB REV C, marked on back upper left. PWR FAULT - Current ...

    • NXT GIOX - Setup and Configuration in Doors.NET

      1.0 Using Standard NXT Controllers The NXT GIOX module is added to standard NXT controllers using Auto-configuration. The GIOX module is connected to the controller via one of the available RS-485 ports (these are labeled on a 4-door controller as ...

    • NXT GIOX - Elevator Control Wiring