NXT-MSC Hardware Cable Requirements

NXT-MSC Hardware Cable Requirements

The attached document provides you with the required cable types to use when installing
NXT-MSC 2 door or 4 door controllers.
    • Related Articles

    • NXT-MSC 2D/4D Controller Hardware Installation Guide

      1.0 Introduction This document contains basic information for the installation of the NXT-MSC 2D and 4D controllers. 2.0 Product Specifications 2.1 Unit Dimensions • NXT 2D/4D controller PCB - 6.75 inches high by 6.00 inches wide by 1.75 inches deep, ...
    • NXT-MSC - OSDP Reader Support

      1.0 Introduction OSDP (Open Supervised Device Protocol) is an access control communication standard developed by the Security Industry Association (SIA) to improve interoperability among access security products and is being endorsed by all leading ...
    • NXT-MSC Controller - Firmware Upgrade

      NXT Mercury Powered Controller Firmware Upgrade Procedure When you run the installer you will see a notification if the MSC controller firmware needs upgrading. You will also see a notification in live events when a new controller is added to the ...
    • NXT-MSC - I/O Control Using MR16IN and MR16OUT Modules

      1.0 Introduction Using Doors.NET v4.9.0 and later, you can connect Mercury MR16IN and MR16OUT modules to the RS-485 port of an NXT-MSC controller. Each MR16IN or MR16OUT module has 16 inputs or outputs and therefore offers a very cost-effective means ...
    • NXT-MSC 2D/4D Controller Specifications

      1.0 NXT-2D/-4D Dimensions NXT Enclosure - 13.00 inches high by 10.5 inches wide by 3.00 inches deep - 33.02 cm by 26.67 cm by 7.62 cm. NXT Controller PCB - 6.50 inches high by 5.50 inches wide by 1.00 inches deep, not including wiring connectors - ...