NXT-MSC Hardware Cable Requirements

• Related Articles

• NXT-MSC 2D/4D Controller Hardware Installation Guide

  1.0 Introduction This document contains basic information for the installation of the NXT-MSC 2D and 4D controllers. The NXT-MSC controller has recently been updated from a green PCB to a black colored PCB. All NXT controllers and Keri peripherals ...

• NXT-MSC - OSDP Reader Support

  1.0 Introduction OSDP (Open Supervised Device Protocol) is an access control communication standard developed by the Security Industry Association (SIA) to improve interoperability among access security products and is being endorsed by all leading ...

• NXT-MSC - I/O Control Using MR16IN and MR16OUT Modules

  1.0 Introduction Using Doors.NET v5.2.0, you can connect Mercury MR16IN and MR16OUT modules to the RS-485 port of an NXT-MSC controller after configuring the controller bus to the Mercury Security protocol. Each MR16IN or MR16OUT module has 16 inputs ...

• NXT-MSC 2D/4D Controller Specifications

  1.0 NXT-2D/-4D Dimensions NXT Enclosure - 13.00 inches high by 10.5 inches wide by 3.00 inches deep - 33.02 cm by 26.67 cm by 7.62 cm. NXT Controller PCB - 6.50 inches high by 5.50 inches wide by 1.00 inches deep, not including wiring connectors - ...

• NXT-MSC Controller - Controller Setup Guide

  1.0 Introduction This document covers the basic setup of an NXT Mercury Powered (NXT-MSC) controller in Doors.NET or Borealis. It assumes your Doors.NET or Borealis system has already been setup. Important Notes: A Doors.NET system should be licensed ...