NXT-MSC Controller - Assign a Static IP Address

NXT-MSC Controller - Assign a Static IP Address

Configure the Controller With a Static IP Address

Once the NXT-MSC controller has been added to Borealis you should configure the controller with a static IP address. This can be done via the controller's Internal Configuration menu.

Important Note: Before assigning the controller with a static IP address you should ensure the IP address you wish to assign is not already assigned to another device on the network.
  1. From the Borealis main menu, click on Hardware >> Controllers.



  2. Locate the controller that you have added.
  3. Use the controller's Actions menu located on the right side of the screen and select Configure.



  4. The Internal Configuration form will appear.
  5. From the drop-down menu, select Network.
  6. You will see that by default the Network Method is set to DHCP.
  7. Change the Network Method to Static and then enter the static IP address you wish to assign to the controller.



  8. The Subnet Mask and Default Gateway should not be edited.
  9. Click the SAVE button.
  10. Next, click the APPLY CHANGES and Reboot button.
  11. You will see a notification prompting you to confirm the reboot.



  12. Click Yes to proceed.
  13. The controller will reboot and it will momentarily go offline.
  14. Within a few seconds the controller should be back online and the new, static IP address will be displayed.