NXT-MSC NXT and NXT Exit Reader Wiring
Related Articles
NXT Exit Reader Setup
1.0 Introduction Keri NXT controllers with Mercury Firmware now provide an Entrance/Exit reader door control feature/configuration. This Entrance/Exit feature allows two readers to be wired into one bus on the NXT controller to control entrance and ...
NXT Reader Setup
NXT Readers are used use exclusively with Keri’s revolutionary access control system based on the NXT and the MSC Series of IP-based Controllers. Communication to the readers is via the RS-485 buses allowing the data to be encrypted and built in ...
NXT-1R/-3R/-5R Reader - Installation Guide
1.0 Wiring and Layout Diagrams 1.1 NXT-1R/-3R/-5R Readers This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable ...
Keri NXT Reader Specifications
Specifications: Size: • NXT-3R Euro Mount Prox Reader - 3.25 inches tall by 3.25 inches wide by 0.5625 inches deep - 8.25 cm by 8.25 cm by 1.43 cm (not including wiring connectors) • NXT-5R Mullion Reader - 3.75 inches tall by 1.625 inches wide by ...
NXT 6RK Reader and Keypad Installation Guide
1.0 Introduction The Keri NXT-6RK is a keypad reader typically used for card + PIN dual verification applications. It transmits keypad data in either 8-bit burst (default) or 26-bit Wiegand formats and can be used as a keypad-only device. Since the ...