MSC controller firmware v1.293 addresses the following issue:
• Corrected an issue where the strike time for 4x4 and GIOX units under elevator control stayed active longer than the strike time set for the controller board.
• Corrected an issue where MSC controllers did not set the correct default gateway when set to DHCP mode.
• Corrected a 4x4/GIOX output timing issue that caused relay pulse operations to stick in the ON position requiring a
manual OFF command.
NXT-MSC Controllers with firmware v1.293 are compatible with the following:
• Doors.NET Software v4.0.3.0 or greater
• NXT Readers - 4.00.03 or greater
• Reader Interface Modules (RIMs) - 3.03.21 or greater
• 4x4 I/O Module - 3.00.03
• GIOX Motherboard - 1.00.21 or greater
• GIOX Input Module - 1.00.10 or greater
• GIOX Output Module - 1.00.10 or greater
NOTE: NXT Controllers are compatible with MS readers, 26-Bit Wiegand readers, and non-26-Bit Wiegand readers only when connected via an NXT-RIM (unless you are using OSDP Wiegand readers).