NXT-MSC v1.296 Firmware Release Notes

1.0 NXT-MSC Controller Firmware Release

MSC controller firmware v1.296 addresses the following issue:

• Corrects 4x4 and GIOX elevator control relay mapping issues.

NOTE: If you are using MSC controller firmware v1.294 and are NOT using elevator control, there is no need to update your firmware.

NXT-MSC Controllers with firmware v1.294 and v1.296 are compatible with the following:

• Doors.NET Software v4.0.3.0 or greater

• NXT Readers - 4.00.03 or greater

• Reader Interface Modules (RIMs) - 3.03.21 or greater

• 4x4 I/O Module - 3.00.03

• GIOX Motherboard - 1.00.21 or greater

• GIOX Input Module - 1.00.10 or greater

• GIOX Output Module - 1.00.10 or greater

NOTE: NXT Controllers are compatible with MS readers, 26-Bit Wiegand readers, and non-26-Bit Wiegand readers only when connected via an NXT-RIM.

Related Articles
NXT-MSC v1.293 Firmware Release Notes
1.0 NXT-MSC Controller Firmware Release MSC controller firmware v1.293 addresses the following issue: • Corrected an issue where the strike time for 4x4 and GIOX units under elevator control stayed active longer than the strike time set for the ...
NXT-MSC v1.294 Firmware Release Notes
1.0 NXT-MSC Controller Firmware Release MSC controller firmware v1.294 addresses the following issue: • Corrected a problem specific to NXT-MSC controllers when issuing pulse commands to MR16OUT and GIOX units NOTE: If you are using MSC controller ...
NXT-MSC - OSDP Reader Support
1.0 Introduction OSDP (Open Supervised Device Protocol) is an access control communication standard developed by the Security Industry Association (SIA) to improve interoperability among access security products and is being endorsed by all leading ...
NXT-MSC Controller - Firmware Upgrade
When you run the installer you will see a notification if the MSC controller firmware needs upgrading. You will also see a notification in live events when a new controller is added to the system. Perform the following steps to upgrade the controller ...
How to I Update the NXT-MSC Controller Firmware?
Q. How Do I Update the NXT-MSC Controller Firmware Using the Doors.NET Software? A. The following video explains how to update the firmware on an NXT-MSC 2 or 4-door controller: