PXL-500 Controller Wiring Diagram

PXL-500 Controller Wiring Diagram



    • Related Articles

    • PXL-500 Controller Specifications

      Specifications 1.0 Unit Dimensions • PXL-500/PXL-510 controller PCB - 6.75 inches high by 6.00 inches wide by 1.75 inches deep, including wiring connectors - (17.15 cm by 15.25 cm by 4.45 cm) • PXL-500/PXL-510 controller PCB with an LCD-1 ...
    • PXL-500 RS-485 Network Wiring Test

      1.0 Introduction The RS-485 wiring test is provided for field testing of the RS-485 connection. The RS-485 wiring test is done in two steps. The first step tests the negative side of the RS-485 (TB-1 pin 1 and the second step tests the positive side ...
    • PXL-500 Controller Installation Guidelines

      When Installing Controllers DO • If using modems for communication plan ahead to meet power and any telephone requirements for your system (1 phone line for the modem connected to the host computer and one for each master PXL-500/PXL-510 in each ...
    • PXL Controller Firmware Upgrade

      1.0 Introduction PXL controllers do not have flash firmware and so they require a physical chip change. The PXL Firmware Upgrade ship kit comes with a chip extraction tool to assist with the removal and replacement of chips - failure to use the ...
    • PXL-500 Quick Start Guide

      1.0 Introduction This quick start guide provides, basic installation information, drawings, first time power-on instructions, and short descriptions of key terms and concepts for installing controllers. These instructions apply to the PXL-500 ...