PXL Access Rights Limitations
When using PXL controllers there are certain limitations related to the assignment of access groups. A cardholder can have up to 8 access groups assigned as long as no doors exist in more than one group and providing the doors for a particular controller are added to the same group.
Examples of Assigning PXL Access Rights to Cardholders
- PXL Cardholder Assigned Total Access:
No other group can be assigned because all doors for all PXL controllers exists with the Total Access group.
- PXL Access Group - 1 PXL Controller in each access group
An unlimited number of PXL access groups can be assigned when each group contains a separate PXL controller and as long as a controller does not exist in more than one group.
- PXL doors in different access groups
You cannot select multiple groups if PXL doors exist in two different access groups.
In the image above, controller 8 has its doors in different access groups and so these two access groups cannot both be assigned to the same cardholder. If a cardholder requires access to both these doors they need to be added to the same access group. As shown below:
Related Articles
Cardholder Access Rights
The Access Rights page displays a list of all the access groups that have been defined on the system. Access Groups consist of the readers on the system, along with the associated time schedules. Once access groups have been added to the system they ...Assign an Access Group to a Cardholder
1.0 Introduction Once access groups have been setup they can be assigned to cardholders. 2.0 Access Group Assignment Limitations For NXT controllers there is a maximum of 8 access groups per cardholder. For Neutron controllers there is a maximum of 8 ...Setup PIN-Only Access
PIN-Only Access 1.0 Introduction This document explains how to setup PIN-Only access when using a keypad connected to a PXL-500W or when using NXT and NXT-MSC controllers with a reader interface module. Notes: The feature setup varies slightly ...Temporarily Disable Cardholder Access
1.0 Introduction To provide added flexibility, there are several methods available in Doors.NET for disabling card access or for preventing doors from automatically unlocking - such as for extended periods of un-occupancy or limited occupancy at a ...Setup Elevator Control Access Groups
1.0 Introduction When using Elevator Control with MSC or SCP hardware you have to setup Elevator Access Groups. These are then assigned to a general access group which can then be assigned to a cardholder. 2.0 Create and Assign Elevator Access Groups ...