LAN-520
LAN-520 AESP - Full Installation Guide
1.0 Introduction The following are basic setup steps for the LAN-520 AESP. Some settings may not apply to every application. The following setup instructions explain how to use Lantronix Device Installer to find the DHCP assigned IP address and then ...
Verify Communication By Performing a Telnet Session to Port 10001
This will test the default port used by Doors32/Doors.NET to communicate to the device. The telnet command is preferred over the ping command in testing communications because the telnet command will give a specific response from the device, whereas ...
LAN-520 - Enhanced Security Settings
1.0 Introduction If the LAN-520 channel 1 port # has been changed to 1234 then this is highly indicative that the device has been hacked. The default value for the port number is 10001. This is the number that identifies the channel for remote ...
LAN-520 and NC-485 Network Converter Setup Guide
1.0 Introduction The NC-485X offers you more flexibility in managing multiple, remote, physical sites and enhanced networking capability. By using the LAN-520X in combination with an NC-485X Network Converter, PXL-500 controllers, which are normally ...
LAN-520 - Quick Start Guide
1.0 Introduction The following steps explain how to setup a PXL-500 in the Doors.NET software using a LAN-520 module. It assumes you have worked through the steps to install and license the Doors.NET software and that you have also setup the PXL ...
Troubleshooting LAN-520
LAN-520 Troubleshooting 1.0 Cannot Connect to the PXL Network - Check the LAN-520 IP address and port number is correct in the Doors.NET software. The IP address should match the address which has been programmed in the LAN-520. - By default, the ...