Installation/Setup Guides - Series 2 (EP) Hardware
Single Door Module (SDM) MR51 Setup
Single Door Module (SCP-SDM) Setup in Doors.NET The SCP-SDM (Single Door Module) has all the I/O needed for controlling a single door. Each SDM will interface one card reader, two general purpose input monitor points and two control relays to provide ...
Dual Door Module (DDM) MR52 Setup
SCP MR52/DDM Setup Power Supply to the MR52-S3 The MR52-S3 accepts either 12Vdc or 12Vac for power. Locate the power source as closed to the interface as possible. Make power connection with minimum of 18AWG wires. The input voltage is filtered and ...
EP4502 Controller Setup Guide
EP4502 Controller Setup 1.0 Introduction The setup for the EP-4502 controller is very much the same as the EP-1502 and EP-2500. All EP controllers are pre-configured for use on a network, therefore additional TCP/IP configuration must take place in ...
MR16OUT Module Installation Guide
MR16OUT Module Installation Guide (Attached)
MR16IN Module Installation Guide
MR16IN Module Installation Guide (Attached)
MR51E Controller Installation Guide
MR51E Controller Installation Guide (Attached)
EP1502 Controller Installation Guide
EP1502 Controller Installation Guide and Specifications (Attached)
EP1501 Controller Installation Guide
EP1501 Controller Installation Guide and Specifications (Attached)
EP4502 Controller Installation Guide
EP4502 Controller Installation Guide (Attached)
EP2500 Controller Installation Guide
EP2500 Intelligent Controller Installation Guide (Attached)
EP1501 Controller Setup Guide
1.0 Introduction The EP1501 is an edge-capable intelligent controller that is expandable up to 8 downstream serial input/output modules and up to 16 MR62e network ready door controllers (for a total of 17 doors/openings). The feature-rich EP1501 ...
Mercury EP-Series - Full Setup and Configuration Guide
1.0 Introduction This section explains how to setup and configure all controller settings and advanced options. All these settings can be found either by logging into the controller via a web browser or by accessing the controller's 'internal ...
EP1502/EP2500 Controller Setup Guide
1.0 Introduction The EP1502 controller is Mercury's next-generation advanced access control platform. They have direct hardware support for 2 openings and can scale to 64 access points. The EP4502 provide a two-door interface with auxiliary I/O, ...