With GIOX Firmware 01.00.21, the LEDs have the following functions: USER LED2 - reserved for future use USER LED1 - reserved for future use DIAG - lit if board is REV B or older. Current is PCB REV C, marked on back upper left. PWR FAULT - Current ...
Specifications Dimensions Stand Alone Unit with Back Plate • 15.45 inches wide by 11.56 inches tall by 2.00 inches deep Unit in Standard Enclosure • 17.25 inches wide by 15.25 inches high by 6.75 inches deep (including enclosure cover) Power and ...
1.0 Using Standard NXT Controllers The NXT GIOX module is added to standard NXT controllers using Auto-configuration. The GIOX module is connected to the controller via one of the available RS-485 ports (these are labeled on a 4-door controller as ...
1.0 Introduction The GIOX unit can be used either for elevator control or for large scale general I/O (you cannot perform both functions on the same GIOX unit). It is made up of a motherboard, input modules, and output modules, all mounted to a back ...
1.0 Introduction Doors.NET comes with a generic import utility that can be used to import card data from an Excel (XLS or XLSX) spreadsheet. This is not a licensed feature so it can be used free-of-charge with Doors.NET. 2.0 Configure the Import ...
Manual Enrollment in Doors.NET NXT, MS and 26-bit Wiegand credentials can be manually enrolled by entering the card's imprint (the number printed on the outside of the card), MS and Wiegand cards also require a facility code. The manual enrollment ...
1.0 Writing a Credential Format to the Reader From the Windows start menu, go to All Apps >> RF Ideas >> rf IDEAS Configuration Utility v6.0.9 Accept the terms of the utility license agreement and click the AGREE button. The user interface will ...