NXT-MSC 2D/4D | Firmware Release Notes

Firmware Release Notes
NXT-MSC v1.296 Firmware Release Notes
1.0 NXT-MSC Controller Firmware Release MSC controller firmware v1.296 addresses the following issue: • Corrects 4x4 and GIOX elevator control relay mapping issues. NOTE: If you are using MSC controller firmware v1.294 and are NOT using elevator ...
NXT-MSC v1.294 Firmware Release Notes
1.0 NXT-MSC Controller Firmware Release MSC controller firmware v1.294 addresses the following issue: • Corrected a problem specific to NXT-MSC controllers when issuing pulse commands to MR16OUT and GIOX units NOTE: If you are using MSC controller ...
NXT-MSC v1.293 Firmware Release Notes
1.0 NXT-MSC Controller Firmware Release MSC controller firmware v1.293 addresses the following issue: • Corrected an issue where the strike time for 4x4 and GIOX units under elevator control stayed active longer than the strike time set for the ...

Popular Articles
Generic Database Import (Excel Spreadsheet)
1.0 Introduction Doors.NET comes with a generic import utility that can be used to import card data from an Excel (XLS or XLSX) spreadsheet. This is not a licensed feature so it can be used free-of-charge with Doors.NET. 2.0 Configure the Import ...
NXT 2D/4D Fail-Safe Lock Wiring
PXL-500 Controller Wiring Diagram
Doors.NET - Migrating a System
1.0 Introduction There are several steps that need to be taken to successfully transfer a Doors.NET installation onto a different host PC. It is important that these steps are performed in the exact order that they are listed: Important Notes: The ...
Doors.NET - Software Installation Guide
1.0 Introduction Installing the Doors.NET software is very easy and straight-forward. There are just a few host PC requirements that should be met prior to performing the installation: The host PC must be fully up-to-date with the latest Windows ...

NXT-MSC 2D/4D | Firmware Release Notes | Knowledge Base