Setup Guides
Doors32 to Doors.NET Networking Setup Procedure
1.0 Introduction The NC-485 module was designed to provide RS-485 connectivity across an Ethernet network and to simplify the management of a Doors32 system - as it allowed multiple PXL networks to be combined and then administered and monitored as a ...
PXL-500 Setup in Doors.NET with a LAN-520
1.0 Introduction This guide explains how to setup a PXL-500 in the Doors.NET software using a LAN-520 module. It assumes you have worked through the steps to install and license the Doors.NET software and that you have also setup the PXL gateway. In ...
Standard Versus Legacy PXLs in Doors.NET
Identifying Standard and Legacy PXL Controllers The following PCB part numbers are non Legacy PCBs. All earlier PCB part numbers designate Legacy PCBs. Standard Versus Legacy Entraguard Controllers The easiest method for identifying Standard versus ...
PXL-500 Setup in Doors.NET With a USB-Serial Adapter
1.0 Introduction This guide explains how to setup a connection to a PXL-500 Primary controller using a USB-serial adapter. The adapter used in this example is the Keyspan 19-HS by TRIPP-LITE which is one that Keri highly recommends. It is robust, ...
PXL-500 Setup in Doors.NET
1.0 Introduction This section covers the basic configuration of PXL controllers in Doors.NET software. It assumes Doors.NET has already been successfully installed on your host PC, the software license has been activated, and the PXL gateway has been ...