Hardware Installation
Excluding a Reader From Your Subscription
1.0 Introduction A Borealis system incurs a charge for your hub(s) and also any readers that will be used on the system. By default all of the controller's readers are included in the subscription. They may, however, be a situation where you have a ...
Borealis - Hardware Status
1.0 Introduction Hardware status allows a Borealis user to quickly and easily check on the status of a hardware item (such as; a hub, controller, NXT-RIM, NXT readers or NXT 4x4 modules). 2.0 View All Hardware Status To quickly view the status of all ...
Borealis - NXT-MSC Controller Firmware Upgrade
1.0 Introduction The following steps explain how to upgrade the firmware on an NXT-MSC 2D or NXT-MSC 4D controller via the Borealis user interface. 2.0 Check if the Controller Firmware Needs Upgrading Once you have the controller(s) online, open live ...
Borealis - Add an NXT 4x4 Module
The NXT 4×4 module is added to the system via the controller section. Note: It is not currently possible to link inputs to outputs or re-assign the inputs and outputs to door contact, RTE, strike functionality, etc. ...
Borealis - Add an NXT Exit Reader
When using NXT-MSC controllers you can use NXT Exit readers. An exit reader is wired into the same bus as a standard NXT entry reader (as illustrated), to control entrance and exit through a single door. Although just one door is being controlled, ...
Borealis - Add a Controller
Note: If you are using the new user interface, the instructions can be found here: https://help.kerisys.com/portal/en/kb/articles/new-ui-add-controllers NXT-MSC 4-door controller The process of adding a controller to Borealis is the same regardless ...