Entraguard | Entraguard Setup Guides

Entraguard Setup Guides
Entraguard Configuration and Settings
Configuring the EntraGuard Telephone Entry Controller The EntraGuard Controller properties can be viewed by going to Setup >> Hardware Setup >> All. Highlight the EntraGuard in the hardware tree (beneath the PXL gateway) and the controller properties ...
Block Enroll Entraguard Users in Doors.NET
In Doors.NET it is not possible to enroll a block of Entraguard IDs, however it is possible to block enroll cardholders without credentials. You can then manually assign the Entraguard user information after the cardholder enrollment. Block Enrolling ...
Adding and Editing Entraguard Users in Doors.NET
1.0 Introduction Each person to be granted access to secured areas using an Entraguard controller will need a User ID assigned to them. If a mixed PXL/Entraguard system is in use, each person may have assigned to them both a card and a User ID. 2.0 ...
Entraguard Silver Walk-Up Package - Quick Start Guide
Entraguard Silver Walk-Up Package - Quick Start Guide (attached).
Basic Entraguard Controller Setup in Doors.NET
1.0 Introduction Entraguard Doors.NET installation and controller configuration is a three step process. Each of these steps has its own document, with controller configuration broken into separate documents per hardware type. • software installation ...

Popular Articles
Generic Database Import (Excel Spreadsheet)
1.0 Introduction Doors.NET comes with a generic import utility that can be used to import card data from an Excel (XLS or XLSX) spreadsheet. This is not a licensed feature so it can be used free-of-charge with Doors.NET. 2.0 Configure the Import ...
Cardholder Enrollment - Manual Enrollment
Manual Enrollment in Doors.NET NXT, MS and 26-bit Wiegand credentials can be manually enrolled by entering the card's imprint (the number printed on the outside of the card), MS and Wiegand cards also require a facility code. The manual enrollment ...
Using the pcProxConfig Software
From the Windows start menu, go to All Apps >> RF Ideas >> pcProxConfig.exe The user interface will appear as below. Plug the pcProx Plus USB enrollment reader into an available USB port. The reader will beep once and its LED will be red. Verify ...
PXL-500 Controller Data Sheet
PXL-500 Controller Data Sheet (attached)
NXT 2D/4D Controller Factory Reset
Keri recommends resetting NXT controllers the first time these controllers are powered on. Also, under certain circumstances NXT controllers may need to be reset. Note: Factory resetting a standard NXT controller will restore the controller to a ...

Entraguard | Entraguard Setup Guides | Knowledge Base