Borealis - System Configuration

Borealis - System Configuration

Configure The Borealis System


This section explains how to configure a new Borealis access control system. It details all the steps that need to be taken to configure the controller, readers and other hardware as well as access control settings, such as: time schedules, access groups and holidays.

  1. Controller Configuration
  2. Reader Configuration
  3. Setup Time Schedules
  4. Setup Access Rights
  5. Setup Holidays
  6. Cardholder Enrollment



    • Related Articles

    • System Setup

      Introduction Note: If you are using the new user interface, the instructions can be found here: https://help.kerisys.com/portal/en/kb/borealis/new-user-interface/system-setup This section explains how to setup a new Borealis cloud access control ...

    • Borealis Brochure

        Borealis System Brochure

    • Borealis - Glossary of Terms

      Borealis - Glossary of Terms and Conditions Access Control - A general term describing the control, management, and monitoring of the entrance and exit of people through secure areas. Borealis - Keri Systems' access control Cloud solution. Card - An ...

    • Borealis Troubleshooting Guide

      1.0 Borealis System Troubleshooting Cannot view the System - This is most likely caused by the account not being added as a system operator. Once an e-mail has been registered and verified, that e-mail address should then be added as a new system ...

    • Borealis Full Setup Guide

      1.0 Introduction This document aims to guide you step-by-step through setting up a new Borealis system. It explains how to register a new account, create a new system. Add a new site, claim a hub to the site and then add hardware (such as controllers ...