Can I do a Lockdown of All My Doors Using a Panic Button?
Yes you can... included with the Doors.NET software is the ability to use the Global Lock/Lockout/Lockdown feature - supported on all controller types.
Note: For full implementation of Global Lockout and Lockdown, if you are using PXL-500 controllers, all controllers must be at the latest firmware revision (08.06.09).
Related Articles
Lockdown Doors
The Lockdown feature can be set from the software or from the hardware (from an input designated as a Global Lock input). What is Lockdown? Lockdown (or sometimes referred to as Emergency Lockdown) is used to instantly lockdown all doors or certain ...Global Lock, Lockout, Lockdown - Software
1.0 Introduction This section explains how to use the basic Situation Manager feature to set a Global Lock command via an icon in the software, allowing you to immediately lock a designated group of doors, over multiple controllers and even over ...Unlock and Lock Doors Using an Input
1.0 Introduction To program a Global Linkage you must have a Global Linkage license enabled and you must be using Mercury Powered NXT or Standard Mercury controllers. 2.0 Macro Setup From the Global Linkage macros tab click the Add New button. Give ...Using Multiple Hardware Types in Doors.NET
Doors.NET is capable of running multiple concurrent hardware platforms. The ability to support multiple concurrent hardware platforms was introduced in Doors.NET v3.5.1.19. Support for the Entraguard, the PXL-G and the PXL-LC was introduced in ...Global Lock, Lockout, Lockdown - Hardware
1.0 Introduction Doors.NET provides the ability to program any available input on the system to immediately put the system into Lock, Lockout or Lockdown status by activating the input (for example; pressing an emergency button). This feature is ...