PXL-500 Wiring Instructions

Terminal Blocks

Connecting Wires and Removing Terminal Blocks

Note: Screws on terminal blocks must be tightened securely.

Connecting the Earth Ground and the 12 VDC Power

Note: TB2 is colored red to make it easier to tell it apart from the network connector.

• Related Articles

• PXL-500 RS-485 Network Wiring Test

  1.0 Introduction The RS-485 wiring test is provided for field testing of the RS-485 connection. The RS-485 wiring test is done in two steps. The first step tests the negative side of the RS-485 (TB-1 pin 1 and the second step tests the positive side ...

• PXL-500 Quick Start Guide

  1.0 Introduction This quick start guide provides, basic installation information, drawings, first time power-on instructions, and short descriptions of key terms and concepts for installing controllers. These instructions apply to the PXL-500 ...

• PXL-500 Hardware Installation Guide

  1.0 Introduction This document contains basic information for the installation of the PXL-500 Controller. 2.0 Important Note: Keri Public Statement on the Amazon Key Keri does not support the use of the Amazon Key on Keri controllers. The Amazon Key ...

• PXL-500 Controller Specifications

  Specifications 1.0 Unit Dimensions • PXL-500/PXL-510 controller PCB - 6.75 inches high by 6.00 inches wide by 1.75 inches deep, including wiring connectors - (17.15 cm by 15.25 cm by 4.45 cm) • PXL-500/PXL-510 controller PCB with an LCD-1 ...

• PXL-500 Troubleshooting Guide

  Following is a list of possible scenarios you may encounter when setting up or using the PXL-500 controllers. You will then see a possible solution or a list of possible solutions listed in order of the most likely cause: 1.0 Controller Issues Cannot ...