BioSync | Application Notes

Application Notes
BioSync - BioManager Database Backup
The BioManager should be backup on a regular basis (especially if there are changes being made frequently. A full backup of users, settings and BioSync hardware can be made very quickly). You would use the database backup and restore procedure if you ...
BioSync - Migrate the BioManager Software
Perform the following steps to migrate the BioManager installation: 1. Create backup file (menu backup). 2. Using ServerSetup remove service. 3. Install at new PC. 4. Restore backup. Also moving the database folder can do the job, just do not forget ...
BioSync - Using the BioManager Software
1.0 Introduction BioManager software is Client-Server based software. The server is installed only on 1 PC (together with the client) and the client can be installed on other PCs (without the server). If you are using the client from a remote PC and ...
BioSync - How to Install the BioManager Software
The BioManager Software is used to communicate to the BioSync fingerprint readers. Once you have connected to the BioSync devices you can configure them, add users, credentials and fingerprints and run basic diagnostic checks. Installation Procedure ...

Popular Articles
Generic Database Import (Excel Spreadsheet)
1.0 Introduction Doors.NET comes with a generic import utility that can be used to import card data from an Excel (XLS or XLSX) spreadsheet. This is not a licensed feature so it can be used free-of-charge with Doors.NET. 2.0 Configure the Import ...
Cardholder Enrollment - Manual Enrollment
Manual Enrollment in Doors.NET NXT, MS and 26-bit Wiegand credentials can be manually enrolled by entering the card's imprint (the number printed on the outside of the card), MS and Wiegand cards also require a facility code. The manual enrollment ...
Using the pcProxConfig Software
From the Windows start menu, go to All Apps >> RF Ideas >> pcProxConfig.exe The user interface will appear as below. Plug the pcProx Plus USB enrollment reader into an available USB port. The reader will beep once and its LED will be red. Verify ...
PXL-500 Controller Data Sheet
PXL-500 Controller Data Sheet (attached)
NXT 2D/4D Controller Factory Reset
Keri recommends resetting NXT controllers the first time these controllers are powered on. Also, under certain circumstances NXT controllers may need to be reset. Note: Factory resetting a standard NXT controller will restore the controller to a ...

BioSync | Application Notes | Knowledge Base