Elevator Control
Elevator Control Data Sheet
Elevator Control Data Sheet
Setup Elevator Control Access Groups
Introduction When using Elevator Control with MSC or SCP hardware you have to setup Elevator Access Groups. These are then assigned to a general access group which can then be assigned to a cardholder. Create and Assign Elevator Access Groups Next is ...
Elevator Control with Mercury EP/LP Series Hardware
1.0 Introduction Doors.NET supports Elevator Control when using Real Mercury (EP and LP series) controllers and Mercury input modules (MR16IN-S3) and/or output modules (MR16OUT-S3). For many different sized elevator applications this can be an ...
Elevator Control with NXT-MSC and MR16IN/MR16OUT Modules
1.0 Introduction With Doors.NET v4.9.0 and later, you can connect Mercury MR16IN and MR16OUT modules to the RS-485 port of an NXT-MSC controller. Each MR16IN or MR16OUT module has 16 inputs or outputs and therefore offers a very cost-effective ...
Elevator Control - Scheduled Override of Floors
In normal elevator control operating mode access to controlled floors will require the presentation of an access credential to the reader in the elevator cab. Occupancy requirements at some facilities may require that some floors services by the ...
Elevator Control NXT-MSC and NXT GIOX Modules
1.0 Introduction Doors.NET supports Elevator Control when using NXT Mercury Powered controllers and NXT 4x4 modules or GIOX units. For many different sized elevator applications this can be an extremely cost-effective solution. Using GIOX modules you ...
Elevator Control with NXT-MSC and 4x4 Modules
1.0 Introduction Doors.NET supports Elevator Control when using NXT Mercury Powered controllers and NXT 4x4 modules or GIOX units. For many different sized elevator applications this can be an extremely cost-effective solution. With one 4x4 module ...